You can do the work on the router table or you can move a portable router across planted boards.
Tongue and groove router table.
Using a router gives you more options in terms of the approach and the cutters.
For predictable results use the right tools accessories and setup.
Using the table saw is easiest when all the material stock is the same thickness.
So i opted to use a router table.
When cutting joints make sure the router table is clear of sawdust.
You cannot use this bit without a router table because of bit s width.
So let s start the procedure stepwise.
It is mounted upside down in the router table.
Take a one piece of tongue and groove bit and place in the router table.
The heart of this setup is the router motor.
The larger bit cuts the tongue.
Tongue and groove joints can easily be made with a router when using the right bits on a proper router table.
The debris under the wood can cause the cut to be misaligned.
If you don t have any tongue groove router bit then go on amazon and buy it now.
To begin making tongue and groove boards you first must decide to use either a table saw or a router.
Tongue and groove t g joints form sturdy interlocking connections with lots of glue surface area for all sorts of woodworking applications.
Make sure your routing table is clear of sawdust and other debris.
The easiest method and the one i most commonly use is to use the table saw for both the tongue and the groove.
The tongue and groove bits are a matched set.
First it s important to use a powerful router with variable speed control to ensure smooth safe cuts when using these big heavy bits.
The smaller bit on the right cuts the groove.
If you re going to use the former approach you can cut tongue and groove joints with a straight bit a slot cutter or a dedicated tongue and groove cutter assembly or.
This is accomplished by mounting the router s fixed base to a router table insert.
Basically all you need is a router motor router table a tongue groove router bit set a shop vac a couple marking tools and safety equipment.
Washers can be used to adjust the size of both bits if needed.
There s no need for a dado blade if you have a router table and a few common bits.
Cabinet door joints self aligning shelf edging web or face frames and even carcass assembly.
When routing tongue and groove joints consistency is key for a good fit and part alignment.